Winton 1.25m Hydraulic Offset Tractor Flail Mower W‑HF125

The W-HF125 is the smallest mower in Winton's hydraulic offset flail range. At 1.25m it suits smaller compact tractors from 20 HP, where the wider siblings would be too much machine. The hydraulic A-frame slides the deck sideways on the move — handy when you're working tight to hedges, posts or trees.

Built for awkward edges

One double-acting spool drives the side-shift through two hoses, so you offset the cut without leaving the seat or repositioning the tractor. That's the difference between trimming neatly along a fence line and getting off every twenty metres to reset.

Tough weeds, tidy grass

20 hammer-style blades run on a spiral-pattern rotor, powered by PTO through 3 drive belts to the rotor shaft. The mower bites into overgrown weeds and rank grass, but drop the height for regular paddock or orchard work and it leaves a fine finish. Cutting height adjusts from 3–8 cm via the rear roller and twin height-adjustable skids, which also keep the blades off the deck on uneven ground.

Fitment

Three-point Cat 1 hitch with a 77–92 cm lower linkage width. Check your tractor sits inside the 20–40 HP band and has a spare double-acting spool before ordering.

• Hydraulic side-shift A-frame — offsets the deck from the seat to reach hedge bases and fence lines
• 1.25m working width — narrowest in the W-HF family, matched to lower-HP compact tractors and tight headlands
• 20 hammer-style blades on a spiral rotor layout for tougher weeds and a finer cut on short grass
• 3–8 cm cutting height set via adjustable rear roller and 2 height-adjustable skids
• PTO driven with 3 drive belts powering the rotor shaft
• 1 double-acting spool required on the tractor to operate the side-shift
• Lower linkage width 77–92 cm; weight 312 kg