Winton 1.1m Tractor Topper Mower W‑TM110

If your tractor sits in the 16–25 HP bracket, the wider WTM toppers are out of reach. The W-TM110 is the answer — a 1.1m cut that fits tight paddocks, gateways and orchard runs without overworking a small tractor.

Built for small-tractor smallholdings

This is a basic, honest topper. Two blades on a direct-drive carrier swing under a 110 cm deck, leaving wind-rowed cuttings along the skids. Less power draw than a belt-driven mower, and very little to service beyond checking blade condition, gearbox oil and greasing the PTO shaft. It hitches to a Cat 1 three-point linkage with a 45–70 cm lower width.

Topping, plus a bit more

Set short for keeping grazing tidy, or wind the skids down for knocking back brambles, light scrub and saplings on rougher corners of the holding. Cutting height adjusts from 5–25 cm by unbolting the side skids — no tools-on-the-go fiddling, just set it for the job and go.

• 1.1m working width — the narrowest WTM, sized for tight paddocks and gateways
• Matched to 16–25 HP sub-compact and small tractors
• 5–25 cm cutting range, adjusted by unbolting the side skids
• Direct-drive 2-blade rotor — lower power draw than belt-driven toppers
• Shear bolt PTO shaft included to protect the driveline on rough ground
• Stone guard fitted as standard
• Multiple A-frame positions for hitch alignment
• 175 kg, 135 × 125 × 100 cm